This command will set the wireframe state of the specified object.

SET OBJECT WIREFRAME Object Number, Flag

Object Number

Integer
The object number

Flag

Integer
Setting the wireframe to zero will ensure the object is solid. A value of one will cause the object to draw in wireframe form

This command does not return a value.

Setting the wireframe to zero will ensure the object is solid. A value of one will cause the object to draw in wireframe form.

sync on : sync rate 60 : hide mouse:cls 0:color backdrop 0

fog on:fog color 0:set ambient light 50

ObjectNumber=2:ImageNumber=2

wire=0:trans=0:cull=0:fliter=0:light=0:fog=0:ambient=0

set global object creation 0

set dir "models"

load object "ast4.x",ObjectNumber

set object specular ObjectNumber,0

rotate object ObjectNumber,270,0,0

set dir ".."

while mouseclick()<>2

set cursor 0,0

set object wireframe ObjectNumber,wire

if mouseclick()=1 then yrotate object ObjectNumber,wrapvalue(object angle y(ObjectNumber)+1)

sync

endwhile

while mouseclick()=1:endwhile

delete object ObjectNumber

end

BASIC3D Commands Menu
Index